Offering 6 berths in a traditional layout. Up forward is a double V-berth with the heads located neatly underneath. Marine toilet, wash basin with manually pumped cold water. In the saloon there are two single settees either side of a fixed, single drop leaf saloon table. The saloon converts in to a spacious double. Small chart table, port forward part of the saloon with the solid fuel stove opposite. 

Behind the saloon seating and to port is the galley basin with a manually pumped cold water supply. Opposite to starboard is the SMEV four burner gas hob & oven. Good storage around the saloon 

In the port and starboard quarters are two very comfortable quarter berths with plenty of stowage underneath. Good ventilation throughout. Blue patterned upholstery. 100 litre water capacity in a flexible tank. WOOD BURNING STOVE.

Located under the cockpit sole is the 1990 Yanmar 3GM30F marine diesel engine. 27hp, 3 cylinders, freshwater cooled via heat exchanger. Shaft driven to a fixed 3 bladed propeller. Single lever controls. 64 litre stainless steel fuel tank. Two Racor fuel filters, switchable. Portable diesel fuel polishing 12V with parts for permanent installation.

Maxpower 24 volt bow thruster.

• Two 12 volt domestic batteries 
• One 12 volt engine start battery
• Two 12 volt bow thruster batteries connected in series to make 24 volt
• Alternator charging with (to be fitted) Sterling Power charge controller (protects alternator as well). 
• Inverter
• 240volt shore power system with outlets and RCD protection

Gaff rigged cutter. Wooden spars all revarnished in September 2023 (Mast replaced in 2004 by Collars). Deckstepped mast in a tabernacle. Stainless steel standing rigging (2017). Terylene running rigging (2017). Four Harken 16 self tailing sheet winches. Two Harken halyard winches. Davey & Co headsail furling systems. Slab reefing mainsail with lazyjacks.

• Mainsail 
• Staysail 
• Jib 

• Davey & Co manual anchor windlass
• Bruce anchor with approximately 60 metres of chain
• CQR kedge anchor
• Mainsail cover
• Various fenders and warps
• Boarding ladder
• Boat hook

• Steering compass
• Autohelm Tri-data - wind, speed & log
• Clipper wireless windspeed instrument
• VHF
• Simrad TP32 tiller pilot (needs fitting)
• AIS receiver
• GPS
• LED deck bicolour and masthead tricolour navigation lights
• Clock & barometer

• Fire extinguishers
• Fire blanket
• Gas alarm
• Jackstays
• Cockpit harness points
• Horseshoe lifebuoy
• Floating light
• SEAGO 6 person life raft (requires service)
• Manual bilge pump

Cornish Crabbers Pilot Cutter, designed by Roger Dongray. Hull was moulded by Cornish Crabbers in 1990 and delivered to her first owner called Bill Williams who was shipwright and cabinet maker. GRP hull, topsides painted by Suffolk Yacht Harbour in 2023. The hull under the waterline was copper coated by Suffolk Yacht Harbour in 2020. Traditional long keel with steel centre plate. Epoxy sheathed plywood decks which were repainted by Suffolk Yacht Harbour in 2023. Plywood sheathed coachroof. Plywood epoxy sheathed cockpit. Tiller steering to a keel hung rudder. Deep protected cockpit.

The company normally acts as brokers for the vendor who unless otherwise stated is not selling in the course of a business. Whilst every care has been taken in the preparation of these particulars the correctness is not guaranteed and they are intended as a guide only and do not constitute a part of any contract. A prospective buyer is strongly advised to check these particulars and where appropriate and at his own expense to employ a qualified marine surveyor to carry out a survey and/or to have an engine trial conducted which if conducted by us shall not imply any liability on our part.

General note on safety equipment: Any safety equipment such as liferaft, fire extinguishers and flares etc., are usually personal to the current owner(s) and if being left on board as part of the sale of a used vessel, may require routine servicing, replacement, or changing to meet a new owner’s specific needs.